花纹输送带的保养 Maintenance of pattern conveyor belt 1.输送带在运输和贮存中，应保持清洁，避免阳光直射，雨雪浸淋，防止与酸 、 碱、油类，有机溶剂等影 响橡胶质量的物质接触，并距离发热装置1米以外。 The 1. conveyor belt during transportation and storage, should be kept clean, avoid direct sunlight, rain leaching, and prevent acid and alkali, oil, organic solvent affect the quality of rubber material contact, and distance of 1 meters outside the heating device. 2.贮存时库房内温度宜保持在—15℃—+40℃之间，相对湿度宜保持在50—80%之间。 2. storage, the warehouse temperature should be kept at between 15 and +40 degrees centigrade, relative humidity should be maintained between 50 - 80%. 3.贮存中输送带须成卷放置，不得折叠，放置期间应每季翻动一次。 3. storage conveyor belt shall be placed in rolls, shall not fold, during the period should be changed every season. 4.输送带运行速度不应大于5.0米/秒，运输块度大，磨损性大的物料和使用固定犁型卸料装置时应尽量采用低速。超出规定速度时，会影响胶带使用寿命。 4. conveyor belt running speed shall not be greater than 5 meters / second, transport block, wear large materials and the use of fixed plough type unloading device should be used as low speed as possible. Beyond the specified speed, it will affect the service life of the adhesive tape. 5.运输机的传动滚筒直径与输送带布层的关系，传动滚筒改向滚筒的配套以及对托辊槽角的要求，应根据输 送机的设计规定，合理选取。 5. the relationship between the diameter of the transmission roller and the conveyor belt, the matching of the drive drum to the roller and the angle of the roller groove should be rationally selected according to the design requirements of the conveyor. 6.为减轻物料对胶带的冲击与磨损，给料方向应顺胶带的运行方向；物料下落到胶带上的落差应尽量减小；给料口应避开滚筒或托辊的正上方；胶 带受料段应缩短托辊间距 和采取缓冲措施。为防止 刮破胶带，挡料装置刮板清扫装置和卸料装置与胶带的接触 部 分应采用硬度适宜的橡胶板，不要采用夹有布层的胶带头。 6. in order to reduce the impact of material on belt and wear, the feeding direction should be running direction of the tape material falling onto the adhesive tape; the gap should be reduced; just above the feeding mouth should avoid roller or roller belt; the material receiving section should shorten the distance between rollers and take measures to buffer. In order to prevent the scratch tape, blocking the contact part of the cleaning device and the feeding device of scraper unloading device and tape should be used in rubber hardness appropriate, do not use with tape head cloth layer.