1、 输送带在运输和贮存中，应保持清洁，避免阳光直射，雨雪浸淋，防止与酸 、 碱、油类，有机溶剂等影 响橡胶质量的物质接触，并距离发热装置1米以外。

1, the conveyor belt should be kept clean in transportation and storage, avoiding direct sunlight, rain and snow leaching, and prevent contact with substances such as acids, alkalis, Oils and organic solvents affecting rubber quality, and away from the heating device 1 meters away.

2、 贮存时库房内温度宜保持在—15℃—+40℃之间，相对湿度宜保持在50—80%之间。

2. The storage temperature in the storage room should be kept at - 15 - +40 - C, and the relative humidity should be kept between 50 and 80%.

3、 贮存中输送带须成卷放置，不得折叠，放置期间应每季翻动一次。

3, the conveyor belt in storage must be placed in volume, not to be folded, and should be turned every season during the storage.

4、 输送带运行速度不应大于5.0米/秒，运输块度大，磨损性大的物料和使用固定犁型卸料装置时应尽量采用低速。超出规定速度时，会影响胶带使用寿命。

4, the running speed of the conveyor belt should not be greater than 5 meters per second. The low speed and large transport size and material must be adopted when using the fixed plough type unloading device. When the specified speed is exceeded, the service life of the tape will be affected.

5、 运输机的传动滚筒直径与输送带布层的关系，传动滚筒改向滚筒的配套以及对托辊槽角的要求，应根据输 送机的设计规定，合理选取。

5, the relation between the diameter of the transmission cylinder and the conveyor belt, the matching of the transmission drum to the drum and the requirement for the slot angle of the supporting roller should be selected according to the design regulations of the conveyor.