Conveyor belt storage method:

输送带运输储存使用中，如果有不当，将延短输送带的使用寿命，更坏的是会导致输送带破损，不能够正常使用，所以我们要了解正确使用输送带，及一些常用规范：

The conveyor belt storage use, if there is improper, will delay the short service life of the conveyor belt, the worse is to cause the conveyor belt is damaged, can not be used normally, so we need to understand the proper use of the conveyor belt, and some common norms:

1、输送带在运输和贮存中，应保持清洁，避免阳光直射，雨浸淋，防止与酸、碱、油类，有机溶剂等影响橡胶质量的物质接触，并距离发热装置1米以外。

1, the conveyor belt during transportation and storage, should be kept clean, avoid direct sunlight, rain leaching, and prevent acid and alkali, oil, organic solvent affect the quality of rubber material contact, and distance of 1 meters outside the heating device.

2、贮存时库房内温度宜保持在-15 --+40 之间，相对湿度宜保持在50-80%之间

2, storage, the warehouse temperature should be kept between -15 --+40, relative humidity should be maintained between 50-80%

3、输送带运行速度一般不宜大于20.5米/秒，运输块度大，磨损性大的物料和使用固定犁型卸料装置时应尽量采用低速。超出规定速度时，会影响胶带使用寿命。

3, conveyor belt speed is generally not more than 20.5 meters / sec, transport block, wear large material and use fixed plough type unloading device should try to use low speed. Beyond the specified speed, it will affect the service life of the adhesive tape.

4、贮存中，输送带须成卷放置，不得折迭，放置期间应每季翻动一次。

4, storage, conveyor belt shall be placed into a roll, not folded, placed during turning once every quarter.

5、为减轻物料对胶带的冲击与磨损，给料方向应顺胶带的运行方向；物料下落到胶带上的落差应尽量地减少；给料口应避开滚微或托辊间距和采取缓冲措施。为防止刮破胶带，挡料装置、刮板清扫装置和卸料装置与胶带的接触部分应采用刚度适宜的橡胶板，不要采用夹有布层的胶带头。

5, in order to reduce the impact of material on belt and wear, the feeding direction should be running direction of the tape material falling onto the adhesive tape; the gap should be reduced; feeding mouth should avoid rolling or micro distance between rollers and take measures to buffer. In order to prevent the scratch tape, contact material retaining device, scraper cleaning device and unloading device and belt should adopt the rubber plate stiffness suitable, do not use with the tape head cloth layer.